Warning:
Holder under pressure. Protect from the sun and a temperature higher than 50 ° C. Do not pierce or burn, even after use. On curing, acetic acid is released. Use in well-ventilated area.
Irritating to eyes and skin, in case of contact with eyes, rinse immediately with plenty of water and seek expert advice.
After contact with skin, wash immediately with soap and water.
Keep out of reach of children.
Important: Do not apply on head gaskets or in constant contact with gasoline.
Instructions:
1. Surface must be clean, dry and free of grease.
2. Cut the nozzle to the desired thickness.
3. Turn the regulator to open the valve. this raises the lever as much as possible.
4. Place the nozzle at the start of the connections to be made. Press the lever and pull the spout along the joint / surface in a smooth motion.
5. The Menge of emerging kit can be adjusted by turning back the controller.
6. After use, fully turn the controller back, the lever drops and the valve closes. Place the cap so that the hardening for the kit in the spout is delayed.
7. If the connection has to be dismantled later, lubricate some oil on one of the contact surfaces. Do not over tighten the connection!
Do not over tighten the connection!
Gasket rot is resistant to high temperatures up to 343 ° C (short-term)
Hergestellt aus the EU
Bestellnummer: 5-1 Re-seal
